The daily maintenance of the edge banding machine, the precautions before starting and the precautions when debugging the equipment?

The daily maintenance of the edge banding machine, the precautions before starting and the precautions when debugging the equipment?

answer:

1. Daily handover must be cleaned, and a small amount of lubricating oil must be added to the equipment where the oil should be added (such as: front and rear saw guide rails, adjustment screws, conveyor belts and other frequently moving parts)

2. The equipment should be kept clean and hygienic frequently during work, so as to ensure the quality of the edge banding and prolong the service life of the equipment.

3. The protective cover must be covered when working. If there is a power failure during the working process, the workpiece must be taken out from under the pressure roller.

4. If there is a malfunction or abnormal noise during work, the power should be turned off immediately, and the maintenance personnel should be notified, and the equipment can be turned on after the equipment is restored.

5. Before starting the machine, be sure to check whether the lubricating oil, air pressure, and sol temperature meet the starting requirements.

6. It is strictly forbidden to place any sundries on the equipment, and the surrounding area should be kept unobstructed to ensure safe operation.

7. When debugging equipment, all emergency stop switches must be turned off to ensure equipment and personal safety